How To Change Porsche Brake Pads

Today, I’m going to show you how to change Porsche brake pads. This is a task that can be done at home with some basic tools and a little bit of know-how. Changing your brake pads is an important part of maintaining your Porsche’s braking system, and it’s a lot cheaper than taking it to a mechanic. So, let’s get started!

What You’ll Need

Before we dive into the steps, let’s go over the tools and supplies you’ll need for the job:

• Jack and jack stands
• Lug wrench
• Brake pad spreader
• Torque wrench
• Brake cleaner
• New brake pads
• New brake pad retaining clips (if needed)
• New brake pad wear sensors (if needed)

Step 1: Preparing Your Porsche

First things first, make sure your Porsche is parked on a flat surface and the emergency brake is engaged. Then, loosen the lug nuts on the wheel you’ll be working on. Next, use a jack to lift the car off the ground and place jack stands under the car for added safety.

Step 2: Removing Old Brake Pads

Once your car is safely elevated, remove the lug nuts and take off the wheel. Then, remove the brake caliper by removing the bolts that hold it in place. Be careful not to damage the brake line or brake pad wear sensor, if equipped.

Once the caliper is off, you’ll be able to see the brake pads. Take note of how they’re installed and then remove them. You might need to use a brake pad spreader to compress the piston on the caliper so the old pads can be removed.

Step 3: Installing New Brake Pads

With the old brake pads removed, it’s time to install the new ones. First, clean the brake caliper with brake cleaner to remove any dirt or debris. Then, install the new brake pads, making sure they’re oriented the same way as the old ones.

If your Porsche has brake pad wear sensors, make sure to install new ones as well. Also, check the retaining clips that hold the brake pads in place. If they’re worn or damaged, replace them with new ones.

Step 4: Reinstalling the Brake Caliper

Once the new brake pads are installed, it’s time to put the brake caliper back in place. Use a torque wrench to tighten the bolts to the manufacturer’s specifications. Be sure not to over-tighten them.

Step 5: Reattaching the Wheel

With the new brake pads and caliper installed, it’s time to put the wheel back on. Tighten the lug nuts by hand first and then use a torque wrench to tighten them to the manufacturer’s specifications. Then, lower the car back down to the ground and remove the jack stands.

Step 6: Testing Your Porsche

Finally, it’s time to test your Porsche’s new brake pads. Start the car and pump the brakes a few times to make sure they’re working properly. Then, take your car for a test drive and make sure everything feels good.

There you have it, folks – a step-by-step guide on how to change Porsche brake pads. It might seem intimidating at first, but with the right tools and a little bit of patience, you can save yourself some money and keep your Porsche running smoothly. Just be sure to follow these steps carefully and take your time. Thanks for tuning in, and we’ll see you next time!